I²S Audio Speaker

The i2s_audio speaker platform allows you to receive audio via the the I²S Audio Component.

This platform only works on ESP32 based chips.

Warning

Audio and voice components consume a significant amount of resources (RAM, CPU) on the device.

Crashes are likely to occur if you include too many additional components in your device’s configuration. In particular, Bluetooth/BLE components are known to cause issues when used in combination with Voice Assistant and/or other audio components.

# Example configuration entry
speaker:
  - platform: i2s_audio
    dac_type: external
    i2s_dout_pin: GPIOXX

Configuration variables:

  • dac_type (Required, enum):

    • external: Use an external DAC, for example the NS4168, or UDA1334A.

    • internal: Use the internal DAC

  • channel (Optional, enum): The channel of the speaker. One of left, right, mono, or stereo. If stereo, the input data should be twice as big, with each right sample followed by a left sample. left and right mute the unused channel, while mono plays the same samples on both. Defaults to mono.

  • sample_rate (Optional, positive integer): I2S sample rate. Defaults to 16000.

  • bits_per_sample (Optional, enum): The bit depth of the audio samples. Note that while set to 24bit or 32bit, the samples will be scaled up from 16bit before being forwarded. One of 8bit, 16bit, 24bit, or 32bit. Defaults to 16bit.

  • bits_per_channel (Optional, enum): The bit depth of the audio channels. See the datasheet of your I2S device for details. Defaults to bits_per_sample.

  • use_apll (Optional, boolean): I2S using APLL as main I2S clock, enable it to get accurate clock. Defaults to false.

  • i2s_mode (Optional, enum): The I²S mode to use. One of primary (clock driven by the host) or secondary (clock driven by the attached device). Defaults to primary.

  • i2s_audio_id (Optional, ID): The ID of the I²S Audio you wish to use for this speaker.

  • timeout (Optional, Time): How long to wait after finishing playback before releasing the bus. Defaults to 100ms.

External DAC

  • i2s_dout_pin (Required, Pin Schema): The GPIO pin to use for the I²S DOUT (Data Out) signal.

For best results, keep the wires as short as possible.

Internal DAC

  • mode (Required, enum): The channel mode of the internal DAC.

    • left

    • right

    • stereo

See also